Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

FAQ within [ Options ]

41-50 of Total 129

prev 5 / 13page next
  • FR-HC2

    Because RSO (converter reset) of the HC2 is connected to RES of the inverter, the inverter is reset along with the HC2 reset. (Refer to the wiring diagram in... More Details >>

    • No:20948
    • Release Date:2018/08/22 16:25
  • Installation method

    If multiple line noise filters are wound without clearance between them, the noise reduction effect corresponding to the number of filters cannot be obtained... More Details >>

    • No:22087
    • Release Date:2018/08/22 16:30
  • Proper use of AC reactor and DC reactor

    1. ACL has the input power factor of approximately 90% and DCL has the input power factor of approximately 95%. Therefore, DCL has a higher input power facto... More Details >>

    • No:21949
    • Release Date:2018/08/22 16:30
  • Inverter selection when multiple inverters are to be connected

    Be sure to use a high power factor converter with the capacity higher than the total capacity of the inverters connected. (Note: One or more of the inverters... More Details >>

    • No:21565
    • Release Date:2018/08/22 16:28
  • Built-in reactor

    The reactor built in the FREQROL-A201 series is intended to stabilize operation of the converter circuit and differs from the FR-BAL. Note that when performi... More Details >>

    • No:21421
    • Release Date:2018/08/22 16:27
  • Using the inverter near a large power supply system

    Use the AC reactor. More Details >>

    • No:21171
    • Release Date:2018/08/22 16:26
  • FR-CV

    Use the FR-HC to suppress harmonics. It also supports power supply regenerative driving.The FR-CV and FR-RC are both power supply regeneration units.The diff... More Details >>

    • No:22038
    • Release Date:2018/08/22 16:30
  • EMC compliant filter terminal cover

    The SF1258 has the terminal cover.Although the SF1259 to SF1263 do not have the terminal covers and their terminals are bare, rubber tubes to cover them are ... More Details >>

    • No:21956
    • Release Date:2018/08/22 16:30
  • Waveform improvement

    A reference sine wave signal is generated inside the high power factor converter, and transistors are configured and PWM switching is performed in the conver... More Details >>

    • No:21574
    • Release Date:2018/08/22 16:28
  • FR-LU08

    It is general type button battery (CR1216 × 1). More Details >>

    • No:21088
    • Release Date:2018/08/22 16:25

41-50 of Total 129

Inquiries