Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ Others ]

11-20 of Total 53

prev 2 / 6page next

  • MM-EF/EFS

    Yes, the 7.5 kW or lower motor can be used for belt drive hanging and direct connection. Note that the standard models of 11 kW or higher motor are dedicated... More Details >>

    • No：20962
    • Release Date：2018/08/22 16:25

  • Countermeasure against inverter noise

    You can attach the following filters to the inverter input side:- Line noise filter (FR-BLF, FR-BSF01)- Radio noise filter (FR-BIF) 　While it is a good idea ... More Details >>

    • No：21528
    • Release Date：2018/08/22 16:28

  • Installation dimensions of the heat sink panel through attachment

    The heat sink panel through attachment to the FR-A520-5.5K inverter consist of the top installation frame, bottom installation frame, and upper cover. The to... More Details >>

    • No：21520
    • Release Date：2018/08/22 16:28

  • Built-in reactor

    The reactor built in the FREQROL-A201 series is intended to stabilize operation of the converter circuit and differs from the FR-BAL. Note that when performi... More Details >>

    • No：21421
    • Release Date：2018/08/22 16:27

  • Communication option

    You can remove the parameter unit FR-PU02 and install the FR-CU01 there. However, since the interface for the parameter unit is used, the communication speed... More Details >>

    • No：21625
    • Release Date：2018/08/22 16:28

  • Selection

    It is not completely recommended to use F700P because the starting torque at low speed of the hydraulic pump may be larger than that of the normal pump. Sele... More Details >>

    • No：21126
    • Release Date：2018/08/22 16:26

  • No load current value of motor

    No load current for each power supply voltage is as follows:- Approximately 15.5 A for 200 VAC 60 Hz- Approximately 21.7 A for 220 VAC 60 HzThe current is es... More Details >>

    • No：21534
    • Release Date：2018/08/22 16:28

  • Energy saving and power supply capacity of inverter

    Energy saving is achieved by switching from the commercial power supply to the inverter to operate the motor. When the inverter reduces motor speed, it also... More Details >>

    • No：21498
    • Release Date：2018/08/22 16:27

  • How can I calculate the processing torque from the measured power?

    You can calculate the torque from the power. 　From the general equation: Pout = ωn × TT = (Pout × τ)/ωnPout: Measured valueωn: Actual motor shaft angular fre... More Details >>

    • No：21475
    • Release Date：2018/08/22 16:27

  • Can you provide the CAD data?

    The CAD data is found on the member's page of Mitsubishi Electric FA Global Website. More Details >>

    • No：22091
    • Release Date：2018/08/22 16:30

11-20 of Total 53

Inquiries

Contact Us

page top