Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ Others ]

1-10 of Total 53

prev 1 / 6page next

  • Selection

    It is not completely recommended to use F700P because the starting torque at low speed of the hydraulic pump may be larger than that of the normal pump. Sele... More Details >>

    • No：21126
    • Release Date：2018/08/22 16:26

  • Can you provide the CAD data?

    The CAD data is found on the member's page of Mitsubishi Electric FA Global Website. More Details >>

    • No：22091
    • Release Date：2018/08/22 16:30

  • FR-FS2

    The description has been deleted because there is no industrial pressure ventilation fan that can be used for the FR-FS2, due to the production termination o... More Details >>

    • No：21064
    • Release Date：2018/08/22 16:25

  • Number of years of service life designated by law

    The number of years of service life of the inverter is not designated by law. More Details >>

    • No：21497
    • Release Date：2018/08/22 16:27

  • FR-PA07

    Its protective structure conforms to IP20.Therefore it is not waterproof. More Details >>

    • No：21701
    • Release Date：2018/08/22 16:28

  • Influence on external measurement device

    It is considered that malfunction of the measurement device is due to noise. Check the noise propagation route since the countermeasure depends on it. Some c... More Details >>

    • No：22100
    • Release Date：2018/08/22 16:30

  • Parameter list

    The setting memo of the parameter list seal is not provided with the FR-A500 Instruction Manual. More Details >>

    • No：21485
    • Release Date：2018/08/22 16:27

  • How can I calculate the processing torque from the measured power?

    You can calculate the torque from the power. 　From the general equation: Pout = ωn × TT = (Pout × τ)/ωnPout: Measured valueωn: Actual motor shaft angular fre... More Details >>

    • No：21475
    • Release Date：2018/08/22 16:27

  • MM-EF/EFS

    Since the standard bearing is adopted for the belt drive models, a creep may occur and the motor bracket may wear out. More Details >>

    • No：20964
    • Release Date：2018/08/22 16:25

  • Countermeasure against harmonics

    When the high power factor converter is installed, you can use the conversion coefficient of K5 = 0 for calculation. In accordance with the harmonic suppress... More Details >>

    • No：21398
    • Release Date：2018/08/22 16:27

1-10 of Total 53

Inquiries

Contact Us

page top