Start main contents

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E700 ]

151-160 of Total 394

prev 16 / 40page next

  • Advanced magnetic flux vector control

    Check the parameters necessary for tuning again.Check if Pr.9 (Electronic thermal O/L relay) and Pr.81 (Number of motor poles) are set correctly. More Details >>

    • No：21754
    • Release Date：2018/08/22 16:29

  • Operation panel (FR-PA02)

    Set Pr.146 (Built-in potentiometer switching) to "0".This allows for using the potentiometer built in the FR-PA02 to set the frequency.(Set this parameter to... More Details >>

    • No：21729
    • Release Date：2018/08/22 16:29

  • Switching between external operation ...

    You can monitor the fault output in both NET operation and external operation. More Details >>

    • No：21686
    • Release Date：2018/08/22 16:28

  • Frequency setting

    Even though the maximum frequency setting is changed using CC-Link, the running frequency is not changed. By writing the set frequency to the remote register... More Details >>

    • No：21346
    • Release Date：2018/08/22 16:27

  • Applied terminal

    As described in the instruction manual, use the shielded cable or twisted cable to avoid the influence of noises. More Details >>

    • No：21344
    • Release Date：2018/08/22 16:27

  • Brake resistor

    Connect the brake resistor to the terminal P and terminal PR. (For the FR-A700-7.5K or lower, remove the jumper of the terminals PR and PX.) Do not remove th... More Details >>

    • No：21333
    • Release Date：2018/08/22 16:27

  • Installation of options

    Use the digital output/additional analog output FR-A7AY (E kit). More Details >>

    • No：21290
    • Release Date：2018/08/22 16:26

  • Start command

    Set Pr.338 (Communication command source) to "0" to give a start command from "NET". Set Pr.339 (Speed command source) to "1" to make a frequency setting fro... More Details >>

    • No：21285
    • Release Date：2018/08/22 16:26

  • Noise filter

    The noise filter is not built-in the FR-E700 series. It is built in the FR-A700/F700 series with the 55K or lower capacity. More Details >>

    • No：21276
    • Release Date：2018/08/22 16:26

  • Wiring and terminal

    The ferrule terminal or single wire can be used for the control circuit wiring. More Details >>

    • No：21275
    • Release Date：2018/08/22 16:26

151-160 of Total 394

page top