Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E700 ]

11-20 of Total 394

prev 2 / 40page next

  • Replacement

    It is Pr.125 (Terminal 2 frequency setting gain frequency). Adjust the slope with C4 (903) (Terminal 2 frequency setting gain) as necessary. More Details >>

    • No：21247
    • Release Date：2018/08/22 16:26

  • Operation method

    Set Pr.79 (Operation mode) to "3" and Pr.161 (Frequency setting/key lock operation selection) to "1". More Details >>

    • No：21249
    • Release Date：2018/08/22 16:26

  • Frequency command

    Since the initial value of Pr.13 (Starting frequency) is 0.5 Hz, the operation does not start unless 0.5 Hz or higher frequency is set. When 0.49 Hz is set i... More Details >>

    • No：21251
    • Release Date：2018/08/22 16:26

  • Driving a single-phase motor

    No, it cannot. More Details >>

    • No：21253
    • Release Date：2018/08/22 16:26

  • CC-Link communication

    After setting Pr.79 (Operation mode selection) to "2" and Pr.340 (Communication startup mode selection) to "10", reset the inverter (or power ON again) to st... More Details >>

    • No：21256
    • Release Date：2018/08/22 16:26

  • Frequency setting signal

    Check that the wiring of the terminal 4 and 5 are not reversed. More Details >>

    • No：21266
    • Release Date：2018/08/22 16:26

  • Brake resistor

    The brake resistor is MRS120W200. More Details >>

    • No：21274
    • Release Date：2018/08/22 16:26

  • Wiring and terminal

    The ferrule terminal or single wire can be used for the control circuit wiring. More Details >>

    • No：21275
    • Release Date：2018/08/22 16:26

  • Noise filter

    The noise filter is not built-in the FR-E700 series. It is built in the FR-A700/F700 series with the 55K or lower capacity. More Details >>

    • No：21276
    • Release Date：2018/08/22 16:26

  • Specifications

    It can be driven by connecting single-phase 200 V to the terminals R and S. In this case, the load current must be one-third or less of the inverter rated cu... More Details >>

    • No：21282
    • Release Date：2018/08/22 16:26

11-20 of Total 394

Inquiries

Contact Us

page top