Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E700 ]

281-290 of Total 394

prev 29 / 40page next

  • Frequency setting

    Use the setting dial to set the frequency with the FR-E700.You can also use the setting dial to set the parameters.(By setting Pr.161, you can use the settin... More Details >>

    • No：21918
    • Release Date：2018/08/22 16:30

  • Frequency setting

    You can connect up to three inverters to a single external frequency setting potentiometer to control them.　　 More Details >>

    • No：21917
    • Release Date：2018/08/22 16:30

  • External 0 to 10 VDC input

    Checking terminals used:Are the terminals MRS and RES open?Are the terminals STR and SD short-circuited correctly?Is the voltage/current switch of the termin... More Details >>

    • No：21916
    • Release Date：2018/08/22 16:30

  • Frequency setting

    Set Pr.125 (Terminal 2 frequency setting gain frequency) = "90 Hz".This changes the frequency with the potentiometer turned to the maximum position (at 5 V i... More Details >>

    • No：21909
    • Release Date：2018/08/22 16:30

  • Frequency setting

    You can do so by setting Pr.73 to "10" or "11". (For A700/F700 (P), supply negative input to the terminal 1.) More Details >>

    • No：21908
    • Release Date：2018/08/22 16:30

  • Frequency setting

    Since Pr.125 (Terminal 2 frequency setting gain frequency) is initially set to 60 Hz, change it to 85 Hz. More Details >>

    • No：21907
    • Release Date：2018/08/22 16:30

  • CC-Link

    Set Pr.550 (NET mode operation command source selection) to "2" (PU connector is the command source).When operating the inverter using the USB connector, set... More Details >>

    • No：21904
    • Release Date：2018/08/22 16:30

  • CC-Link

    Set Pr.340 (Communication startup mode selection) to other than "0".Also, set Pr.79 (Operation mode) to "0", "2", or "6".Powering the inverter on automatical... More Details >>

    • No：21903
    • Release Date：2018/08/22 16:30

  • CC-Link

    You can start/stop operation, set the frequency, read/write parameters, and monitor the inverter via CC-Link communication. More Details >>

    • No：21901
    • Release Date：2018/08/22 16:29

  • CC-Link

    If you are using CC-Link just to monitor the inverter and using the analog signal and multi-speed setting to set the frequency, you need to input them extern... More Details >>

    • No：21900
    • Release Date：2018/08/22 16:29

281-290 of Total 394

Inquiries

Contact Us

page top