Start main contents

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-E700 ]

1-10 of Total 394

prev 1 / 40page next

  • CC-Link communication

    After setting Pr.79 (Operation mode selection) to "2" and Pr.340 (Communication startup mode selection) to "10", reset the inverter (or power ON again) to st... More Details >>

    • No：21256
    • Release Date：2018/08/22 16:26

  • Real sensorless vector control

    No, Real sensorless vector control cannot be used in the FR-E700. More Details >>

    • No：21269
    • Release Date：2018/08/22 16:26

  • Motor coasting

    To set the motor to coasting state, the following methods are available: 1. Set Pr.250 (Stop selection) to "0" and turn OFF the start command. 2. Short the t... More Details >>

    • No：21271
    • Release Date：2018/08/22 16:26

  • Brake unit

    The brake unit operates when the bus voltage exceeds the brake operation voltage. More Details >>

    • No：21272
    • Release Date：2018/08/22 16:26

  • Brake resistor

    The brake resistor is MRS120W200. More Details >>

    • No：21274
    • Release Date：2018/08/22 16:26

  • Wiring and terminal

    The ferrule terminal or single wire can be used for the control circuit wiring. More Details >>

    • No：21275
    • Release Date：2018/08/22 16:26

  • Noise filter

    The noise filter is not built-in the FR-E700 series. It is built in the FR-A700/F700 series with the 55K or lower capacity. More Details >>

    • No：21276
    • Release Date：2018/08/22 16:26

  • Input phase loss

    The detection time 1 s cannot be changed. More Details >>

    • No：21277
    • Release Date：2018/08/22 16:26

  • Torque control

    Torque control cannot be performed with the FR-E700 series. It is available with the FR-A700 and FR-V500 series. More Details >>

    • No：21279
    • Release Date：2018/08/22 16:26

  • Specifications

    It can be driven by connecting single-phase 200 V to the terminals R and S. In this case, the load current must be one-third or less of the inverter rated cu... More Details >>

    • No：21282
    • Release Date：2018/08/22 16:26

1-10 of Total 394

page top