Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-D700 ]

251-260 of Total 261

prev 26 / 27page next

  • Auto tuning

    With the monitor indicator "1", there is no problem with the parameter setting of auto tuning. Check if the terminals MRS and SD are not shortened in the wir... More Details >>

    • No：21294
    • Release Date：2018/08/22 16:26

  • Installation direction

    Horizontal installation prevents heat release, resulting in a failure. Install the inverter vertically. More Details >>

    • No：21286
    • Release Date：2018/08/22 16:26

  • Frequency

    When the torque is supposed as 100% at 60 Hz, the torque becomes 75 % at 80 Hz. (Under V/F control, the torque decreases when the frequency exceeds 60 Hz bec... More Details >>

    • No：21284
    • Release Date：2018/08/22 16:26

  • Brake resistor

    The brake resistor is MRS120W200. More Details >>

    • No：21274
    • Release Date：2018/08/22 16:26

  • Frequency setting signal

    Check that the wiring of the terminal 4 and 5 are not reversed. More Details >>

    • No：21266
    • Release Date：2018/08/22 16:26

  • Driving a single-phase motor

    No, it cannot. More Details >>

    • No：21253
    • Release Date：2018/08/22 16:26

  • Frequency command

    Since the initial value of Pr.13 (Starting frequency) is 0.5 Hz, the operation does not start unless 0.5 Hz or higher frequency is set. When 0.49 Hz is set i... More Details >>

    • No：21251
    • Release Date：2018/08/22 16:26

  • Operation method

    Set Pr.79 (Operation mode) to "3" and Pr.161 (Frequency setting/key lock operation selection) to "1". More Details >>

    • No：21249
    • Release Date：2018/08/22 16:26

  • Replacement

    It is Pr.125 (Terminal 2 frequency setting gain frequency). Adjust the slope with C4 (903) (Terminal 2 frequency setting gain) as necessary. More Details >>

    • No：21247
    • Release Date：2018/08/22 16:26

  • Wiring length

    The total wiring length is as follows: 100 m + (20 m × 5) = 200m. More Details >>

    • No：21144
    • Release Date：2018/08/22 16:26

251-260 of Total 261

Inquiries

Contact Us

page top