Start main contents

Factory Automation

FAQ

Factory Automation

FAQAbout Products

  • Font Size
  • S
  • M
  • L

Keyword Search

You can search two or more words separated by a space. 
 AND : Put a space between the words in a keyphrase.
 OR  : Add a vertical bar ( | ) between the words in a keyphrase.
 NOT : Add a minus sign ( - ) followed by the words that you would like to exclude.

FAQ within [ FREQROL-A700 ]

151-160 of Total 352

prev 16 / 36page next

  • Parameter setting software

    The parameter setting software we provide is the FR Configurator (FR-SW3-SETUP-WJ). You must purchase it to use. Once you purchase the software, you can upgr... More Details >>

    • No：21673
    • Release Date：2018/08/22 16:28

  • Network operation

    Yes. With the setting "66", you can choose NET operation when X66 is ON, and external operation when X66 is OFF. More Details >>

    • No：21675
    • Release Date：2018/08/22 16:28

  • Electronic thermal O/L relay setting

    When using multiple motors, connect an external thermal for each of them. Set Pr.9 to "0" to disable the function. (When multiple motors are present, it is n... More Details >>

    • No：21676
    • Release Date：2018/08/22 16:28

  • Terminal

    Change Pr.126 (Terminal 4 frequency setting gain frequency). More Details >>

    • No：21677
    • Release Date：2018/08/22 16:28

  • Frequency setting

    Yes, you can set Pr.20 to 20 Hz. More Details >>

    • No：21683
    • Release Date：2018/08/22 16:28

  • Frequency setting

    Adjust the terminal 2 bias with Pr.C2 and Pr.C3, and the terminal 2 gain with Pr.125 and Pr.C4. Set Pr.C2 (Terminal 2 frequency setting bias frequency) to 20... More Details >>

    • No：21685
    • Release Date：2018/08/22 16:28

  • Switching between external operation and NET operation

    You can monitor the fault output in both NET operation and external operation. More Details >>

    • No：21686
    • Release Date：2018/08/22 16:28

  • Stop-on-contact control

    Set Pr.270 (Stop-on-contact control) to "1".Set Pr.184 (RES terminal function selection) to "3" to choose the RT signal function.When the terminals RL and RT... More Details >>

    • No：21691
    • Release Date：2018/08/22 16:28

  • FR-Configurator

    If the values are already entered in the setting column, performing batch write reflects the setting on the inverter. More Details >>

    • No：21709
    • Release Date：2018/08/22 16:29

  • FR-Configurator

    No. You cannot connect it to multiple inverters.You can only connect a single personal computer to a single inverter via USB. More Details >>

    • No：21710
    • Release Date：2018/08/22 16:29

151-160 of Total 352

Inquiries

Contact Us

page top